Ocena wątku:
  • 0 głosów - średnia: 0
  • 1
  • 2
  • 3
  • 4
  • 5

[ RSS ] RouterOS 6.47beta60 [Testing]
#1
Information 

RouterOS 6.47beta60 [Testing]

6.47beta60 changelog:

Important note!!!

- The Dude server must be updated to monitor v6.46.4 and v6.47beta30+ RouterOS type devices.
- The Dude client must be manually upgraded after upgrading The Dude server.
- Make sure LTE APN Profile name does not match any of the DHCP server's names if LTE passthrough is used.
- The Dude requires "winbox" policy instead of "dude" to monitor v6.46.4 and v6.47beta30+ RouterOS type devices.

MAJOR CHANGES IN v6.47:
----------------------
!) dns - added client side support for DNS over HTTPS (DoH) (RFC8484);
!) socks - added support for SOCKS5 (RFC 1928);
!) user - enable "winbox" policy for groups with "dude" policy;
----------------------

Changes in this release:

!) dns - added client side support for DNS over HTTPS (DoH) (RFC8484);
!) socks - added support for SOCKS5 (RFC 1928);
*) branding - improved branding package installation process when another branding package is already installed;
*) chr - enabled support for VMBus protocol version 4.1;
*) chr - improved system stability when running CHR on Hyper-V;
*) crs3xx - fixed hardware offloaded bonding on Ethernet interfaces for CRS354 devices;
*) crs3xx - fixed switch rule "dst-port" parameter for IPv6 traffic on CRS305-1G-4S+, CRS326-24G-2S+, CRS328-24P-4S+, CRS328-4C-20S-4S+, netPower 15FR devices;
*) crs3xx - improved system stability when creating multiple hardware offloaded bonding interfaces (introduced in v6.47beta49);
*) crs3xx - show correct switch model for netPower 15FR device;
*) defconf - fixed default IP address assigning on non-paired 60 GHz devices;
*) disk - improved disk management service stability when receiving bogus packets;
*) dns - added support for forwarding DNS queries of static entries to specific server (CLI only);
*) dns - added support for multiple type static entries (CLI only);
*) email - added support for multiple "to" recipients (CLI only);
*) graphing - improved graphing service stability when receiving bogus packets;
*) ike1 - do not try to keep phase 2 when purging phase 1;
*) ike2 - added support for RADIUS Disconnect-Request message handling;
*) interface - increased loopback interface MTU to 65536;
*) ipsec - allow specifying two peers for a single policy for failover (CLI only);
*) lora - added "altitude", "latitude" and "longitude" to stat json if GPS is available;
*) lte - improved stability during firmware upgrade process;
*) routerboard - added "hold-time" parameter to mode-button menu (CLI only);
*) routerboard - added "reset-button" menu - custom command execution with reset button (CLI only);
*) snmp - fixed "ifSpeed" reporting for tunnel interfaces;
*) ssh - improved SSH service stability when receiving bogus packets;
*) switch - correctly display switch statistics when all switch ports are disabled on RTL8367 switch chip;
*) switch - fixed missing switch statistics (introduced in v6.47beta49);
*) user - improved user management service stability when receiving bogus packets;
*) webfig - fixed WinBox download link;
*) webfig - fixed skin usage from branding package;
*) winbox - added "bus" parameter for "USB Power Reset" command on RBM33G;
*) winbox - allow to specify any ethernet like interface under "Tool/WoL" menu;
*) winbox - fixed "Tx/Rx Signal Strength" value presence for 4 chain interfaces;
*) winbox - fixed memory leak (introduced in v6.46.4);
*) winbox - fixed wireless interface "HT" tab setting presence when "band=5ghz-n/ac";
*) winbox - increased limit of multi-entry fields to 100;
*) winbox - limit number of simultaneous WinBox sessions to 5 for users without "write" permission;
*) wireless - improved management service stability when receiving bogus packets;
*) wireless - updated "south africa" regulatory domain information;

Other changes since v6.46.5:

*) bonding - improved slave interface MAC address handling;
*) bonding - prefer primary slave MAC address for bonding interface;
*) branding - do not ask to confirm configuration applied from branding package;
*) branding - fixed identity setting from branding package;
*) branding - properly use HTML files for Hotspot (introduced in v6.47beta);
*) bridge - added logging message when a host MAC address is learned on a different bridge port;
*) bridge - added warning message when port is dynamically added to entry with VLAN range (CLI only);
*) bridge - correctly remove disabled MSTI;
*) bridge - improved hardware offloading enabling/disabling;
*) certificate - added "skid" and "akid" values for detailed print;
*) certificate - allow dynamic CRL removal;
*) certificate - disabled CRL usage by default;
*) certificate - do not use SSL for first CRL update;
*) chr - added support for file system quiescing;
*) crs3xx - correctly remove switch rules on CRS317-1G-16S+ and CRS309-1G-8S+ devices;
*) crs3xx - do not change bridge host ID's when updating host table (introduced in v6.47beta32);
*) crs3xx - fixed "ingress-rate" property on CRS309-1G-8S+, CRS312-4C+8XG, CRS326-24S+2Q+ devices;
*) crs3xx - fixed QSFP interface linking after removing/inserting QSFP module (introduced in v6.47beta49);
*) crs3xx - fixed QSFP+ interface linking for CRS326-24S+2Q+ device (introduced in v6.47beta19);
*) crs3xx - improved switch host table updating;
*) defconf - fixed "no-defaults=yes" applying default configuration (introduced in v6.47beta);
*) defconf - fixed default configuration initialization if power loss occurred during the process;
*) dhcpv4 - added end option (255) validation for both server and client;
*) dhcpv4-client - improved stability when changing client while still receiving advertisements;
*) dhcpv4-server - disallow zero lease-time setting;
*) dhcpv6-client - improved error logging when when renewed address differs;
*) dhcpv6-server - fixed MAC address retrieving from DUID when timestamp is present;
*) discovery - do not send discovery packets on inactive bonding slave interfaces;
*) discovery - do not send discovery packets on interfaces that are blocked by STP;
*) disk - improved recently created file survival after reboots;
*) dns - added support for exclusive dynamic DNS server usage from IPsec;
*) dot1x - added "radius-mac-format" parameter (CLI only);
*) dot1x - added hex value support for RADIUS switch rules;
*) dot1x - added range "dst-port" support for RADIUS switch rules;
*) dot1x - added support for lower case "mac-auth" RADIUS formats;
*) dot1x - fixed "reject-vlan-id" value range;
*) dot1x - fixed dynamically created switch rule removal when client disconnects;
*) dot1x - fixed port blocking when interface changes state from disabled to enabled;
*) dot1x - improved debug logging output to "dot1x" topic;
*) dot1x - improved value validation for dynamically created switch rules;
*) fetch - fixed "User-Agent" usage if provided by "http-header-field";
*) filesystem - fixed NAND memory going into read-only mode or becoming unstable over time;
*) health - added "gauges" submenu with SNMP OID reporting;
*) hotspot - updated splash page design ('/ip hotspot reset-html' required);
*) ike1 - added error message when specifying "my-id" for XAuth Identity;
*) ike1 - added support for "UNITY_DEF_DOMAIN" and "UNITY_SPLITDNS_NAME" payload attributes;
*) ike1 - improved policy lookup with specific protocol;
*) ike1 - improved stability when performing policy lookup on non-existant peer;
*) ike2 - added support for "INTERNAL_DNS_DOMAIN" payload attribute;
*) ipsec - added "split-dns" parameter support for mode configuration (CLI only);
*) ipsec - added "use-responder-dns" parameter support (CLI only);
*) ipsec - control CRL validation with global "use-crl" setting;
*) ipsec - do full certificate validation for identities with explicit certificate;
*) ipsec - fixed minor spelling mistake in logs;
*) ipsec - improved IPsec service stability when receiving bogus packets;
*) kidcontrol - ignore IPv6 multicast MAC addresses;
*) lcd - fixed LCD service becoming unavailable on devices without LCD screen;
*) led - fixed minor typo in LED warning message;
*) lte - added support for Huawei K5161 modem;
*) lte - added support for NEOWAY N720;
*) lte - added support for multiple passthrough APN configuration;
*) lte - do not allow running "scan" on R11e-4G;
*) lte - fixed "allow-roaming" setting when using LTE network mode on R11e-LTE;
*) lte - fixed "band" value setting when configuration is reset on R11e-4G;
*) lte - fixed multiple APN reactivation after deactivation by operator;
*) lte - made "mac-address" parameter read-only;
*) lte - show "phy-cellid" value only in LTE mode;
*) netinstall - removed "Flashfig" from Netinstall;
*) netinstall - removed "Make Floppy" from Netinstall;
*) netinstall - signed netinstall.exe with Digital Signature;
*) ppp - added support for ZTE MF90;
*) ppp - fixed minor typo when running "info" command;
*) proxy - increased minimal free RAM that can not be used for proxy services;
*) quickset - do not show "SINR" field in Quick Set when there is no data;
*) quickset - removed "EARFCN" field from Quick Set;
*) quickset - removed "LTE band" setting from Quick Set;
*) quickset - show "Antenna Gain" setting on devices without built-in antennas;
*) quickset - use "station-wds" mode when connecting to AP with RouterOS flag;
*) route - improved system stability after reboot with large amount of VLAN interfaces with PPPoE servers attached;
*) routing - improved IGMP-Proxy service stability when receiving bogus packets;
*) sniffer - allow setting port for "streaming-server";
*) snmp - added "dot1qTpFdbTable" OID reporting for Q-BRIDGE-MIB;
*) snmp - changed "upsEstimatedMinutesRemaining" reported value from seconds to minutes;
*) snmp - fixed "dot1dBasePort" index offset for BRIDGE-MIB;
*) snmp - fixed multiple LTE interface OID reporting;
*) snmp - improved OID policy checking and error reporting on "set" command;
*) snmp - improved stability when polling MAC address related OID;
*) ssh - fixed SHA256 user authentication algorithm checking (introduced in v6.46.4);
*) supout - added "dot1x" section to supout files;
*) supout - improved UPS information reporting;
*) switch - made "auto" the default value for "vlan-id" parameter when creating a new static host entry;
*) system - correctly handle Generic Receive Offloading (GRO) for MPLS traffic;
*) system - improved driver loading speed on startup;
*) tr069-client - removed warning log message when not using HTTPS;
*) traffic-flow - added "postDestinationMacAddress" parameter support for IPFIX and Netflow v9;
*) upgrade - fixed space handling in package file names;
*) ups - improved compatibility with APC Smart UPS 1000 and 1500;
*) w60g - fixed link status logging;
*) w60g - improved rate selection in low traffic conditions;
*) w60g - use "arp" and "mtu" parameters from master interface when creating a new station;
*) webfig - updated icon design;
*) winbox - added "Rate" parameter for switch ACL rules;
*) winbox - added "auto-erase" option to "Tool/SMS" menu;
*) winbox - added comment support for "Switch->VLAN" menu;
*) winbox - added support for inline bar graphs for LTE signal values;
*) winbox - aligned all "IP->Traffic Flow->IPFIX" check boxes in single line (WinBox v3.22 required);
*) winbox - allow setting "Primary" parameter for "balance-tlb" bonding interfaces;
*) winbox - fixed "BGP Origin" value display under "IPv6->Routes" menu;
*) winbox - fixed "Data Rate" checkbox alignment (WinBox v3.22 required);
*) winbox - fixed bonding type interface support for "Switch->Host" table;
*) winbox - made "yes" the default value for "Inject Summary LSAs" parameter when creating a new NSSA or STUB area;
*) winbox - removed duplicate "join-eui", "dev-eui", "counter", "chain", "size" and "payload" parameters under "Lora/Traffic";
*) winbox - renamed "Routerboard" to "RouterBOARD" under "System/RouterBOARD" menu;
*) winbox - show "Hardware Offload" parameter for bonding interfaces;
*) winbox - updated icon design;
*) wireless - added "russia 6ghz" regulatory domain information;
*) wireless - allow using "russia4" regulatory domain on RU locked devices;
*) wireless - enabled unicast flood for DHCP traffic on ARM architecture access points;
*) wireless - improved 5GHz interface stability on RB4011iGS+5HacQ2HnD and Audience;
*) wireless - improved system stability on hAP ac^2;
*) wireless - updated "russia4" regulatory domain information;
*) www - added "tls-version" parameter in "IP->Services" menu (CLI only);

Download the new 'RouterOS 6.47beta60' version here: https://mikrotik.com/download


https://mikrotik.com/download/changelogs/testing
Odpowiedz


Podobne wątki…
Wątek: / Autor Odpowiedzi: Wyświetleń: Ostatni post
Ostatni post przez MikroTik
05-26-2020, 04:24 PM
Ostatni post przez MikroTik
05-14-2020, 07:46 PM

Skocz do:


Użytkownicy przeglądający ten wątek: 1 gości